If you’ve come this far, this means you’re almost done with building your FPV drone.
A quick anecdote before we get started. While doing my initial flight test I burned an ESC. I’ve also decided to pull the power for the FPV transmitter straight from the battery rather than the ESC as I feel this might be the culprit for my ESC burning.
O simply go back to your wiring and create another splice to pull power for the transmitter.
You might have notice that I’ve added some gears. This is optional. However, it makes take offs and landings a bit more stable.
I’ve uploaded the landing gear assembly to Thingiverse here: http://www.thingiverse.com/thing:621393
You can print your own. It uses a 3mm aluminum pipe and 2mm screws to hold it in place (M2x12mm Bolt) use a bit of Loctite to prevent wiggling.
These are the same screws that are used to hold your motors in place.
Looks like you’re ready to almost fly now. We’ll have to verify a few things prior to flying.
2-Calibrating flight controller
3-Calibrating Receiver controls
You can start by downloading OpenPilot GCS here: http://wiki.openpilot.org/display/BUILDS/OpenPilot+Software+Downloads
Once you get this installed you’ll notice a usb port on your flight controller time to plug this guy in. At this point make sure you have your props off the quad as this can cause major problems.
You’ll soon be needing the battery to power the ESC’s so make sure you have it charged and ready to go nearby.
Once you launch Openpilot GCS connect your usb and start the “Vehicle Setup Wizard”
Here you’ll first be updating the firmware on your cc3d board so simply go through that process.
-Next, you’ll be talking about choosing and calibrating your ESC’s. Here make sure you choose PWM as the input signal configuration
-Quadcopter as vehicle type.
-Quadcopter X has the quad type
-and 490MHZ for the type of ESC. (rapid ESC)
Next get your battery ready you’ll be calibrating the ESC’ simply follow the steps on screen and go through all the steps.
Last you’ll move on to the Receiver configuration. This is important. Make sure you have the battery plugged in while doing this.
One interesting thing is to make sure you have your controller in Acro mode NOT helicopter mode. Simply follow the prompts on screen to calibrate.
One thing to take not of is my Flight mode switch didn’t register during calibration so I simply used another switch on the controller for this purpose. I went with a 2-state switch but since I plan on using a single flight mode for now it should be fine.
After this It make sense to reduce the aggressiveness of some of the stability parameters.
Here are a few screenshots from how my settings look. I suggest starting with the less aggressive and going up from there.
Pre – flight check:
- Make sure all your props are turning the proper way. So you need to have the proper prop on the proper engine. This is a bit confusing but once I had the proper configuration I simply wrote with a sharpie on my ESC and props in case I need to remove them. (which I actually did)
- Make sure you got your arm setting correct on your transmitter.
- Make sure all cables and ESC’s are mounted properly and nothing is going to get in the way of the turning props.
And here is a video of the maiden flight. Be sure to time this flight to understand the endurance of your quad.
Drop your question in the comments area.